Pre-Shooting Checklist

1. Mechanical & Film Compartment

• ▢ Filter Holder: Verify it is IN PLACE. (Crucial: Prevents light leaks through the filter slot).

• ▢ Spring Motor: Wind the Spring and run the camera briefly to test.
• ▢ Take-up Spindle: Open the Side Door; confirm the spindle rotates while the motor runs.
• ▢ Empty Spool: Ensure an empty Daylight Spool is inside for the take-up reel.
• ▢ Pressure Plate: Check that it is Closed & Locked securely against the film gate.

2. Camera Settings

• ▢ Shutter Mode: Set to "I" (interval) for standard filming. (Only use "T" (time) for long exposures in combination with a single frame (P-picture).
• ▢ Frame Rate: Set the speed dial to 24 fps (or less) before loading.
• ▢ Variable Shutter: Ensure the lever is in the Up (Fully Open) position.
• ▢ Diopter (Oculaire): Adjust the eyepiece until the grain/ground glass is sharp for your vision.

3. Lens & Turret

• ▢ Lens Position: Ensure your "taking lens" is aligned with the Top Opening.
• ▢ Turret Lock: Tighten the turret lever (if applicable) to prevent shifting during movement.

📦 Before Returning to FWP

• ▢ Unload Film: Ensure all film is removed.
• ▢ Spring Tension: DO NOT store the camera with the spring fully wound. Run the motor until the tension is released.
• ▢ Caps: Place the Body Cap (Turret Plug) and Lens Caps back.
• ▢ Accessories: Confirm the Filter Holder, Take-up reel and Crank (if applicable) are included.