Pre-Shooting Checklist

1. Mechanical & Film Compartment

   • ▢  Filter Holder: Verify it is IN PLACE. (Crucial: Prevents light leaks through the filter slot).
   • ▢  Spring Motor: Wind the Spring and run the camera briefly to test.
   • ▢  Take-up Spindle: Open the Side Door; confirm the spindle rotates while the motor runs.
   • ▢  Empty Spool: Ensure an empty Daylight Spool is inside for the take-up reel.
   • ▢  Pressure Plate: Check that it is Closed & Locked securely against the film gate.

2. Camera Settings

   • ▢  Shutter Mode: Set to "I" (interval) for standard filming. 
        (Only use "T" (time) for long exposures in combination with a single frame (P-picture).
   • ▢  Frame Rate: Set the speed dial to 24 fps (or less) before loading.
   • ▢  Variable Shutter: Ensure the lever is in the Up (Fully Open) position.
   • ▢  Diopter (Oculaire): Adjust the eyepiece until the grain/ground glass is sharp for your vision.

3. Lens & Turret

   • ▢  Lens Position: Ensure your "taking lens" is aligned with the Top Opening.
   • ▢  Turret Lock: Tighten the turret lever (if applicable) to prevent shifting during movement.

📦 Before Returning to FWP

   • ▢  Unload Film: Ensure all film is removed.
   • ▢  Spring Tension: DO NOT store the camera with the spring fully wound. Run the motor until the tension is released.
   • ▢  Caps: Place the Body Cap (Turret Plug) and Lens Caps back.
   • ▢  Accessories: Confirm the Filter Holder, Take-up reel and Crank (if applicable) are included.